24/7 Emergency Service101-3993 Henning Drive Burnaby BC V5C 6P7
✉ [email protected]

Faucet & Fixture Installation

New taps are one of the cheapest ways to make a kitchen or bathroom feel renovated. They are also easy to fit badly in a way that shows up six months later.

Newly installed modern bathroom faucet
Faucets & Fixtures

The Part That Shows Is the Easy Part

Anyone can drop a tap into a hole. The parts that matter are underneath: seized valves replaced rather than forced, supply lines of the right length rather than bent double, the fixture pulled down evenly so it does not work loose, and a clean seal at the deck so water does not sit around the base.

We fit all major brands, supply if you want us to, and install what you have already bought if you would rather choose it yourself.

  • ✓All major brands — Moen, Delta, Kohler, Grohe, American Standard and more.
  • ✓Supplied or customer-provided — we will fit what you bought — ask us first if unsure.
  • ✓Valves replaced while we are there — seized isolation valves sorted as part of the job.
  • ✓Old fixture removed — taken away and disposed of.
Book Faucet Installation Call Now

Fixtures We Install

  • Kitchen mixer taps and pull-downs
  • Bathroom basin taps
  • Wall-mounted and widespread sets
  • Filtered drinking water taps
  • Under-sink filter systems
  • Pot fillers
  • Shower and bath trim kits
  • Laundry taps
  • Frost-free outdoor hose bibs
Related

While We Are There

Most calls turn up something else worth looking at. Here is what else we handle.

FAQs

Faucet Installation Questions

A straightforward like-for-like swap is usually under an hour. It takes longer when the existing shut-off valves are seized — common in older Vancouver homes — or when the old fixture has corroded into the counter. We allow for that rather than rushing and cracking a basin.
Often yes, using a deck plate to cover the extra holes, and that is a perfectly good solution on most sinks. Going the other way — needing more holes than your sink has — means drilling, which is fine on stainless and risky on ceramic or stone. We will tell you before you buy the fixture, not after.
Yes. Under-sink filter systems and separate drinking taps are common requests, as are pot fillers over a range. A pot filler needs a supply run to the wall behind the stove, so it is much easier as part of a renovation than as a retrofit — but it is usually possible either way.
We recommend it any time they are seized, weeping or older than the fixture. It adds very little while we are already under the sink, and it means the next repair is a five-minute isolation instead of shutting off the whole house.
We replace hose bibs and fit frost-free versions, which is worth doing in Vancouver before winter. A standard bib with a hose left attached through a freeze is one of the most common causes of a burst pipe inside a wall.

New Taps Fitted Properly

Fixed price, old fixture removed, isolation valves fitted.

Book Now (604) 636-3939
Emergency: (604) 636-3939📅 Book Now